IMPORTANT! We strongly recommend connecting the UDM-Pro to an Uninterruptible Power Supply (UPS), or battery backup device, to prevent power instability issues and hardware damage that may result from relying on the local AC power of a standard outlet. Thread the mounting screws (B) through the rack-mount brackets and the circular ends of the cage nuts. If your mounting rack's holes are rectangular:įasten two cage nuts (C) to each of the mounting rack's support legs. If your mounting rack's holes are circular, fasten two mounting screws (B) through the rack-mount bracket and the rack's support legs. Position the first rack-mount bracket (F) so that its four holes align with the four threading holes on either side of the UDM-Pro.įasten the first rack-mount bracket using four bracket screws (A), then repeat the process with the second rack-mount bracket.Īlign the front-facing holes of the rack-mount brackets with those of the wide rack's support legs. Note: Although the cabling can be located outdoors, the UDM-Pro itself should be housed inside a protective enclosure.
The device should be running after bootup is complete. By default, it is set to DHCP Server with the fallback IP address, 192.168.1.1/24. The SFP+ port supports a 1/10G Ethernet connection. The RJ45 port supports a 10/100/1000 Ethernet connection.
By default, they are set to DHCP Server with the fallback IP address, 192.168.1.1/24. The RJ45 ports support 10/100/1000 Ethernet connections.
Install a 3.5" or 2.5" HDD (not included) to use the device as an NVR for UniFi Protect. SFP+ Speed/Link/Activity LED (Ports 10 - 11) RJ-45 Speed/Link/Activity LED (Ports 1 - 9)
The software will also display the location of the device on the map. This indicates that you clicked Locate in the UniFi Controller software. A display message of "UDM-Pro is Starting."